Foam Wash – COLD (Stand Alone)

This is a FOAM WASH HOT with the heating elements and circuits removed. The Foam Wash Cold requires only a 10 amp power supply as opposed to a 32 amp supply (and can be special ordered in single phase – for those companies and sites where 3 phase power is not available). This Foam Wash Cold has lower running costs (with no heating elements to heat the water) and costs less than the Foam Wash Hot. All other features and specifications remain the same.  

SPECIFICATIONS

  • Operation selection – Off, Prewash, Foam Wash, Pressure Wash, Rinse, Wax
  • Coin or Token Operation – Electronic coin timer, fully adjustable with TIME REMAINING display
  • Pressure Pump – 1500psi using triplex ceramic plungers – water consumption 9 L/min
  • Belt driven motor – 2.2kw (3HP) 415V 3 PHASE, 1450rpm
  • Pulsatron chemical pump for foam wash – Compressed air generated high density foam using mains pressure water and detergent.
  • Connection and Site requirements:
  • Power 415v 3 phase 10 AMP supply (5 pin plug)
  • Water – normal ½” water supply (water volume minimum 15 lpm)
  • Air Compressed at 30 PSI min
  • Easy to understand operating instructions
  • Non scratch foaming brush
  • High pressure steel braided hose with swivel coupling at hand wand.

DIMENSIONS

• Dimensions – cabinet H1820mm, W900mm, D570mm. 
Boom height 3000mm Reach – 2580mm

INCLUDES

  • Twin swivel booms, one for a pressure spray gun, the other for the foam brush
  • 2 x 5mtr hoses
  • Gun with swivel lance 700mm S/S
  • Hogs hair brush and wand
  • 1 x 5ltr wash
  • 1 x 1ltr wax/polish
  • Inbuilt chemical tanks
  • Auto dosage unit

auto valet foam wash inbuilt